IDE Controller

hvilken controller er det???

Det er en Promise ultra 66 IDE

Fra Promise.com

What does it mean when I boot the system and the Ultra66 says, \"BIOS Not Installed\"? 

Cause: No Hard Drives attached to Ultra66. 

Solution: The Ultra66 is fully PnP. This means all the resources that it uses are GIVEN to it by the PnP BIOS on the motherboard. The Ultra66 does support IRQ sharing, but this will not work unless ALL the concerned devices support IRQ sharing. If your motherboard allows you to control the assignment of these resources, you may be able to remedy the problem by \"playing around\" with them. You can also try resetting the configuration data in the CMOS. This is usually an option in the PnP section of the CMOS. The only available settings for this option will be \"Enabled\" and \"Disabled\". Set it to \"Enabled\", save and exit, and reboot. Otherwise, the only way you might be able to affect these assignments is to switch the PCI slot that the card is in. 

jeg har også en promise, bare ultra 100 IDE onboard.
jeg installerede bare cden.
Skal du bruge det eller skal du bare installere det
jeg installerede den kun for at slippe for at se den i min opstart
-underligt spørgsmål-

Har du sat en harddisk på den?

Nej for jeg kan vel ikke sætte noget til den, før den er installeret.

Igen fra Promise.com :)

Problem: Hard Drive not seen, BIOS Not Installed, CMOS Configuration 

Cause: Hard Drive Jumper Settings, Cable Issues, CMOS Configuration, BIOS Version, PCI 2.1 Compliancy, No Hard Drives attached to Ultra66 Card 

Solution: The only reason that the Ultra66 BIOS will not install is if it doesn\'t detect a HDD. If you don\'t have a HDD connected to our card, connect one. If you do, check the HDD jumper settings and cabling. If your HDD is from WD, and it\'s the only device on the cable, remove ALL the jumpers from the HDD. If the problem still exists, contact tech support with the following information. What are the HDDs that you\'re using with the Ultra66? What is the jumper setting on each HDD? What is the version of the BIOS on the Ultra66? Make sure the HDDs on the Ultra66 are defined as \"None\" or \"Not Installed\" in the CMOS. Are the cables that you\'re using with the Ultra66 18\" or less? Try switching the PCI slot that the Ultra66 is in. Try resetting the configuration data in the CMOS. This is usually an option in the PnP section of the CMOS. The only available settings for this option will be \"Enabled\" and \"Disabled\". Set it to \"Enabled\", save and exit, and reboot. 

har du checket inde i din bios,om den er slået til

Ja, det har jeg.
Jeg skal bruge den fordi, jeg har 2HDD,CD drev og en brænder, men vil gerne have en Colorado backup sat til også. Er der forslag til opsætning.

Sæt de 2 harddiske på controlleren.
CD drev og colerado på IDE1
Brænder på IDE2

Jeg prøver at lukke ned og sætte det op

Jamen, så held og lykke.